pdf (2140k) - Adcon Engineering Co

More documents

Recommendations

Info

MICRO-SCREEN ® SystemsMetal Box ControllersMICRO-SCREEN ® Metal Box Controllers• Selectable one- and two-beam floating blanking allows objects (usually workpiece material)to move through the defined area at any point without tripping the final switching devices• Selectable auto power-up mode for applications where a key reset is difficult to perform• Two-digit display provides diagnostic information and indicates number of channels blockedOptical Safety Systems• Welded steel box enclosure with tough, black polyester powder paint finish; rated NEMA 13,IEC IP64• Includes input for Emergency Stop functionNote: For general hookup information, see page 320.ModelsUSCD-1T2MICRO-SCREEN DIN Module ControllersSupplyVoltage115/230V acOutputTypeTripFloatingBlankingFixedBlankingUSCD-1T3 115/230V ac TripNoUSCD-2T2 115/230V ac TripYesUSCD-2T3 115/230V ac TripYes1- or 2-USCD-2T3E* 115/230V ac TripYesbeamUSCD-1L2 115/230V ac LatchNoNoNo. of FSDOutput Contacts2 N.O./4 amps2 N.O. & 1 N.C. Aux/6 amps2 N.O./4 amps2 N.O. & 1 N.C. Aux/6 amps2 N.O. & 1 N.C. Aux/6 amps2 N.O./4 ampsUSCD-2L2 115/230V ac LatchYesUSCT-2T2 24V dc TripYesUSCT-2T3 24V dc TripYes* The suffix “E” adds external device monitoring input2 N.O./4 amps2 N.O./4 amps2 N.O. & 1 N.C. Aux/6 amps78 Banner Engineering Corp. • Minneapolis, MN U.S.A. • bannerengineering.com • Tel: 763.544.3164
RRMICRO-SCREEN ® SystemsMetal Box ControllersSystem Power RequirementsFuse RatingResponse TimeStatus Indicators(on control box and receiver)Diagnostic IndicatorControls and AdjustmentsEmergency Stop Switch InputAuxiliary Monitor RelayOutput Configuration(FSD1, FSD2, and SSD)EnclosureConnectionsOperating ConditionsLight Screen: Less than 38 ms (all lengths)E-Stop: Less than 15 msSize: See dimensions on next page.Material: Welded steel box with black polyester powder paint finish.Rating NEMA 13; IEC IP64See page 320 for general hookup information.Temperature: 0° to +50°C (+32° to 122°F)Relative humidity: 95% maximum (non-condensing)FMEA Tested Per requirements IEC 61496-1 (type 4)Application NotesCertificationsMICRO-SCREEN Metal Box Controller Specifications115/230V ac ±15% (50/60 Hz) @ 55 VA; 24V dc ±15% @ 1.5 Amp. max.115V ac: 1 amp, 250V ac, 230V ac: 0.5 amp, 250V or 24V dc: 2 amp, 250VRed = BLOCKED Flashing red = LOCKOUTGreen = CLEAR Flashing green = BLANKING ONYellow = RESET Double-flashing yellow = Waiting for Power-up Key ResetSingle-flashing yellow = ALIGNMENT. Flash rate increases with the number of sensing beams“made”, solid yellow when aligned and defined area is clear.Two-digit numeric display indicates cause of lockout condition and total number of beams blocked.Keyed RESET of system lockout conditionsFloating blanking selection switches and fixed blanking programming switchesAuto Power-up On-Off switchesEmergency Stop switch must offer two normally closed contacts and be capable of switching 50 mA@ 30V dc. Total resistance limit of 30 Ω. Functional stop category 0 per NFPA 79 and ISO 13850(EN 418), Safety category 4 per ISO 13849 (EN 954-1).Simultaneity requirement < 100 msReed relay; 125V ac or dc max., 500 mA max. (10 VA maximum, resistive load)Forced-guided contact relay (resistive load).USCD-..2: FSD1 & 2, SSD = 250V ac max., 4 amp maxUSCD-..3: FSD1 & 2, CNC = 250V ac max., 6 amp max;SSD = 250V ac max., 4 amp maxMechanical life: 10,000,000 operations (minimum).Electrical life: 100,000 operations (typical @1.0 kVA switching power).Arc suppression is recommended when switching inductive loads. See Warning on page 319.Use of fixed blanking requires sensors with 16 or more light beams. Up to 12 beams or 30% of thetotal number of beams in the array may be blanked, whichever is less. Call factory for applicationsassistance if a greater number of blanked beams is required.IEC 61496-1& 2, TYPE 4Pending: USCT-2T2PresenceSensingDevicePending: USCD-2T3EOptical Safety SystemsBanner Engineering Corp. • Minneapolis, MN U.S.A. • bannerengineering.com • Tel: 763.544.316479
Page 1 and 2: MICRO-SCREEN ® SystemsOptical Safe
Page 3 and 4: MICRO-SCREEN ® SystemsMICRO-SCREEN
Page 5 and 6: Range to 9 m (30') • 31.8 mm (1.2
Page 7: RRRRRRRRRRRRMICRO-SCREEN ® Control
Page 11 and 12: MICRO-SCREEN ® SystemsMetal Box Co
Page 13 and 14: RRMICRO-SCREEN ® SystemsMetal Box
Page 15 and 16: MICRO-SCREEN ® SystemsMetal Box Co
Page 17 and 18: RRMICRO-SCREEN ® SystemsDIN Module
Page 19 and 20: MICRO-SCREEN ® SystemsDIN Module C
Page 21 and 22: RRMICRO-SCREEN ® SystemsDIN Module
Page 23 and 24: MICRO-SCREEN ® SystemsDIN Module C
Page 25 and 26: MICRO-SCREEN ® SystemsModification
Page 27 and 28: MICRO-SCREEN ® SystemsAccessoriesM
Page 30 and 31: MICRO-SCREEN ® SystemsAccessoriesU
Page 32 and 33: MICRO-SCREEN ® SystemsReplacement
Page 34 and 35: MINI-SCREEN ® SystemsSystem Overvi
Page 36 and 37: MINI-SCREEN ® SystemsEmitters and
Page 42 and 43: MINI-SCREEN ® SystemsMetal Box Con
Page 46 and 47: RRMINI-SCREEN ® SystemsMetal Box C
Page 52 and 53: RRMINI-SCREEN ® SystemsMetal Box C
Page 54 and 55: RRMINI-SCREEN ® SystemsDIN Module
Page 56 and 57: RRMINI-SCREEN ® SystemsDIN Module
Page 58 and 59:
MINI-SCREEN ® SystemsCablesMINI-SC
Page 60 and 61:
RMINI-SCREEN ® SystemsModification
Page 62 and 63:
MINI-SCREEN ® SystemsAccessoriesOp
Page 64 and 65:
MINI-SCREEN ® SystemsAccessoriesMS
Page 66 and 67:
RMINI-SCREEN ® SystemsAccessoriesM
Page 68 and 69:
MINI-SCREEN ® SystemsReplacement P
Page 70:
MINI-SCREEN ® SystemsOptical Safet
show all

pdf (2140k) - Adcon Engineering Co

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?