MP Research Catalog - Biopac

52Interface ModulesHLT100C & UIM100CUniversal Interface ModuleThe UIM100C is used to connect 100-series amplifier modules and signal cables to the system andis included in the MP Starter System. Sixteen analog input channels plus 2 analog output channelsare provided via standard 3.5mm phone jacks on the front panel. The back panel provides access to16 digital I/O lines and an external trigger input via screw terminals. Amplifier modules snap ontothe side of the UIM100C for signal routing to the MP data acquisition unit. The output of anyamplifier module snapped to the UIM100C can be monitored, during acquisition, via thecorresponding 3.5mm analog channel phone jack. The UIM100C also provides a direct link to theanalog and digital I/O lines of the MP device when collecting or sending data to externalequipment. See page 88 for cables to interface your equipment to the UIM100C.IMPORTANT USAGE NOTEMains powered external laboratory equipment should be connected to an MPSystem through Signal Isolators when the system also connects to electrodesattached to humans. For analog signals, use the INISO or OUTISO isolator(with the HLT100C) to couple external equipment to an MP System. Fordigital signals, use the STP100 (with the UIM100C) to couple externalequipment to an MP System. Contact BIOPAC for details.• UIM100C(if purchased separately)UIM100C SPECIFICATIONSAnalog I/O Access: 16 channels (frontpanel) – 3.5mm phonejacksD/A Outputs: 2 channels (front panel)– 3.5mm phone jacksDigital I/O Access: 16 channels (backpanel) – screw terminalsExt. Trigger Access: 1 channel (back panel) –screw terminalIsolated Power Access:±12V, +5V @ 100 ma(back panel) – screwterminalsWeight:520 gramsDimensions: 7cm (wide) x 11cm(deep) x 19cm (high)IPS100CIsolated Power Supply ModuleNEWNot for use with an MP data acquisition module.The IPS100C is used to operate 100-series amplifier modulesindependent of an MP data acquisition unit. The IPS100C modulecouples the 100-series amplifier outputs directly to any other dataacquisition system, oscilloscope or chart recorder. Amplifier modulessnap onto the side of the IPS100C to receive the necessary isolatedpower and to direct the modules’ output to the front panel of theIPS100C SPECIFICATIONSAmplifier Output Access: 16 channels (front panel)– 3.5mm phone jacksIsolated Power Access: ±12V, +5V @ 100 ma(back panel) – screwterminalsWeight:610 gramsDimensions:7cm (wide) x 11cm(deep) x 19cm (high)Power Source:12VDC @ 1 amp (usesAC100A transformer)IPS100C. The IPS100C allows you to operate up to 16 amplifiers on a stand-alone basis. The analog channel outputsare provided via 3.5mm phone jacks on the front panel. The IPS100C is generally used with animal or tissuepreparations. When collecting data from electrodes attached to humans, use the HLT100C module with INISO andOUTISO signal isolators to couple signals to mains powered external laboratory equipment.IMPORTANT USAGE NOTEDo not use the IPS100C with an MP based system. For a fully isolated recording system using the IPS100C, couple signal inputs and outputsthrough the HLT100C module and INISO and OUTISO adapters, respectively. Contact BIOPAC for details. Includes In-line Transformer(AC100A) and MP System Guide. Specify USA or EURO power cord.• IPS100C