MP Research Catalog - Biopac

88Cables & AccessoriesAnalog Connection CablesAnalog Connection CablesThese cables connect stand-alone laboratory equipment to an MPSystem. Analog outputs from chart recorders, preamplifiers,oscilloscopes, force plates, chromatographs, etc. can be connectedto the UIM100C module. It’s also possible to use these cables toconnect amplifier outputs or D/A outputs to external equipmentCBL101inputs. When signal isolation is required, use the INISO orOUTISO adapter with the cable. The other end of the isolationadapter connects to the appropriate MP System channel via theHLT100C module. Select the cable number with the plugcorresponding to your equipment’s output or input jack. Use one cableper recording channel.CBL102 CBL105CBL100CBL106The CBL106 is a multi-purpose adapter used in conjunction with the CBL102 to connect a BNC cable to the digital I/O lines on the UIM100Cor to the input of the DA100C. It also connects the STM100C to nerve conduction chambers (CBL102 required).• CBL100• CBL101• CBL102• CBL105• CBL106• CBL107• CBL1082m, 3.5mm phone plug to same2m, 3.5mm phone plug to male RCA2m, 3.5mm phone plug to male BNC2m, 3.5mm phone plug to 6.3mm (1/4") phone plug10cm, female BNC connector to a pair of 2mm plugs (requires CBL102)10m, 3.5mm phone plug to same60m, 3.5mm phone plug to sameCalibration Standard for LDF100CThe LDFCAL is a specially prepared colloidal solution of suspended latex spheres undergoing Brownian motion. The LDFCAL provides a standardcalibration value of 1000 BPU ±5% @ 21°C. Probes are calibrated to a specific LDF100C module by placing the probe in the LDFCAL solutionand pressing the CAL button on the LDF100C front panel. A small clamp is provided with the LDFCAL to hold probes securely in the solution.The LDFCAL has a limited lifetime, so it’s best to order it only when required. See the LDF100C on page 60.• LDFCALNEWConnector Kit for MCE100C Micro-electrode AmplifierMCEKITCBuild your own customized adapter to a micro-electrode shielded cable. Cable shields can be tied toa voltage follower drive or simply grounded. Input capacity compensation and clamp current options canbe independently added to or removed from your cable configuration. The MCEKITC comes with sevenattached Touchproof sockets and instructions; mount your interface connector to the housing and solderwires to the sockets. See the MCE100C on page 61.• MCEKITC