Software for the synchronization of axes - Kollmorgen

More documents

Recommendations

Info

SOCAPEL SA SOFTWARE FOR SYNCHRONIZATION OF AXES 024.8068.A8.7 SWITCHING THE SYNCHRONIZING FUNCTION8.7.1 SynchronizingParagraph 8.6.1 mentioned two operating modes : synchronized and desynchronized,selected by the variable FLSUIV. This variable stores the mode requested in the"synchronize" and "desynchronize" instructions. Synchronizing can be achieved evenif the master shaft is rotating. It will be appreciated that if FLSUIV is switched to followa master shaft that is already rotating, then the speed reference VIREF will undergo ajump.VIREFtFigure 8.5This situation is inadmissible since it would cause infinite acceleration and throw outthe slaving system. Hence the necessity to "assist" the speed-change by applying acontrolled acceleration through the IRG.Since VIREF = VGES . KA before synchronizing, and VIREF = VMUS + VGES . KAafter synchronizing, it is simply necessary to reinitialize VGES to ensure that VIREFremains unchanged at the point of synchronicity.This is achieved by subtracting the value of VMUS/KA from VGES. Now the sum willbe identical at the initial instant. Afterwards the internal reference generator willchange VGES to a new value (null or otherwise), respecting the required accelerationvalues.70
SOCAPEL SA SOFTWARE FOR SYNCHRONIZATION OF AXES 024.8068.AExample :Synchronizing a stopped motor with a rotating master shaft :VInstruction receivedVMUStVVMUSas seen behindthe switchVtVGEStVCA2VIREFtFigure 8.6The principle allows for a VGES speed other than null before and after synchronizing.VInstruction receivedVMUStVVMUSas seen behindthe switchVtVGESVCA2CA1tVIREFtFigure 8.771
Page 1 and 2:
Socapel ST1A Digital Motion Control
Page 3 and 4:
SOCAPEL SA SOFTWARE FOR SYNCHRONIZA
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20: SOCAPEL SA SOFTWARE FOR SYNCHRONIZA
Page 49 and 50: 49Figure 8.1 : Reference computer+
Page 69: SOCAPEL SA SOFTWARE FOR SYNCHRONIZA
Page 115: SOCAPEL SA SOFTWARE FOR SYNCHRONIZA
show all

Software for the synchronization of axes - Kollmorgen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?