scsi interface specification - Plasmon

DRIVE COMMAND SET REQUEST SENSE (03H)ADDITIONALSENSE CODES(BYTE 12)QUALIFIERS(BYTE 13)(1)All values are hexadecimalTable 40. Additional Sense Codes (1) (Continued)DESCRIPTIONSENSE KEY(BYTE 2)0 0 Blank Check 80 0 Command Aborted by Host B48 0 Initiator Detected Error B49 0 Illegal Message B4E 0 Overlapped Commands Attempted B0 0 Equal Condition on Media Scan CNOTEAn ASC of 44, ASCQ 80, will be reported when the LaserDriveperforms a reset to recover from a controller detected error.Additional Sense Code Drive Not Ready (ASC 04) will be reported forMEDIA ACCESS commands and Busy Status will be reported for theSTART/STOP command until the reset has completed.At that time, Sense Key 6 (UNIT ATTENTION) will be reported withASC 44, ASCQ 80.If AutoSpin was enabled from the DOC or by Mode Select, the drivewill become ready when the AutoSpin has completed. If AutoSpin wasnot enabled, the drive must be spun up before it will become ready.PLASMON L M S - LD 6100/LF 6600/LF 6602 SCSI INTERFACE SPECIFICATIONPage 106