scsi interface specification - Plasmon

DRIVE COMMAND SETWRITE AND VERIFY (2EH)WRITE AND VERIFY (2EH)The WRITE AND VERIFY command requests the LaserDrive to write on the media all data transferredfrom the Initiator and then verify that the data is correctly written.WRITE AND VERIFY Command (2EH)BITBYTE7 6 5 4 3 2 1 000 WRITE AND VERIFY (2EH)01 LUN 0 Reserved02 Logical Block Address (MSB)03 Logical Block Address04 Logical Block Address05 Logical Block Address (LSB)06 Reserved07 Transfer Length (MSB)08 Transfer Length (LSB)09 ReservedLogical Block AddressThe Logical Block Address specifies the logical block where the write/verify operation will begin.Transfer LengthThe Transfer Length specifies the number of contiguous logical blocks of data to be transferred. ATransfer Length of zero indicates no data to be transferred. This is not considered an error condition. Anyother value indicates that number of logical blocks will be transferred.The errors and conditions for the WRITE AND VERIFY command are the same as those for WRITE. Referto Table 45 in the WRITE Command section and the NOTE that follows the table.97653978 HPage 121