scsi interface specification - Plasmon

DRIVE COMMAND SETMODE SELECT (15H)SSDISThe START/STOP Switch Disable (SSDIS) bit reports whether the front panel switch on the DOC will beignored (refer to the LD 6100/LF 6600LF 6602 Product Specification). An SSDIS bit of one indicates thatthe Start/Stop switch on the LaserDrive front panel will be ignored. Also, a Unit Attention will be generatedonly when the TEST switch is pressed. "Denied" will be displayed when either switch is pressed.An SSDIS bit of zero indicates that the Start/Stop switch will be honored. The action of the START/STOPcommand is not affected. The default SSDIS value is zero.LASERFILE MEDIA STATUS PAGE (LF 6600/LF 6602 ONLY)The Mode Select Media Status page allows selection of a media which will be loaded into the drive after areset, a power up or after the door is opened. If the home position is selected, then no media will beinserted into the drive. The shuttle will then move to the home position and await a MOVE MEDIAcommand.Mode Select/Media Status Page (21H) - LF 6600/LF 6602 OnlyBITBYTE7 6 5 4 3 2 1 000 Reserved Page Code (21H)01 Parameter Length (02H)02 Reserved AutoLoad Selection Reserved03 ReservedAutoLoad Selection (ALS)The AutoLoad Selection (ALS) field is a numeric field indicating which media is selected for auto load, asindicated in the following list. The default is 1 (slot 1).BITS 4 - 6ADDRESS0 Home Position1 Slot 12 Slot 23 Slot 34 Slot 45 Slot 56 Slot 67 MRU (Most Recently Used)97653978 HPage 75