scsi interface specification - Plasmon

DRIVE COMMAND SET REQUEST SENSE (03H)Table 41. 6000 - Byte 18 Error Codes (Continued)BYTE 18 ERROR CODESDESCRIPTION21 DI Recovery Error - Read Only22 Media Management Read Map Failure (LM 4000 only)23 Alternate Write Failure (Channel A)24 Alternate Write Failure (Channel B)25 Map Write Failure (Channel A)26 Map Write Failure (Channel B)27 Undefined28 Cannot Read SDI/PSI29 SDI/PSI Checksum Failure2A2B2CParms FailureRelocation Area Is FullAlternate Area Is Full2D Map and Alternate Write Failure (Channel A)2E Map and Alternate Write Failure (Channel B)2FUndefined30 Map Recovery Failure31 Undefined32 Alternate Recovery Failure33 Excessive Unmapped Alternates34 Undefined35 Scan Condition Met36 No Laserdrive Status37 Four Consecutive Map Write Failures On This Laserdrive38 Unable To Write Due To Previous Performance Monitor Failure39 Performance Monitor Failure 10% of Write Extent Failed3A3B3C3D3E3FUnknown Control Record FailureEDC ASIC Transfer ErrorDiagnostic FailurePrimary/Secondary Map MismatchThis Media Read Only Due to Failed Media Management RecoveryUndefined40 SDI/PSI RWS Data Failure41 Spares 50% Full Side A42 Spares 70% Full Side APLASMON L M S - LD 6100/LF 6600/LF 6602 SCSI INTERFACE SPECIFICATIONPage 108