BaseStation 3200 User Manual - Baseline Systems

C h a p t e r 5 – R e f e r e n c e5 ReferenceSection Contents Dial Positions ......................................................................................................................55 Two-wire Devices ................................................................................................................73 BL-Commander (Handheld Radio Control) ..........................................................................77 BaseManager (Central Control Software) ...........................................................................76 Warranty .............................................................................................................................76Dial PositionsAuto/RunThis is the dial position for normal wateringoperation once the controller has beenprogrammed. There is a lot of informationdisplayed on this main screen about the current operation of the controller. Each of these fieldswill be described:Air Temp – if there is an air temperature sensor on the two-wire this will display thecurrent temperature.Remote – this displays that status of either a BL-Commander handheld radio or aBaseManager central control interface. The possible states are none, idle, and active.Two-wire – this indicates the current in amps being supplied to the two-wire. This willindicate off when the two-wire is powered down.Flow – if there are one or more flow devices, this willindicate the most recent flow reading. With multiple flowdevices, the display will rotate between each of themevery few seconds. Flow readings are read each minute.Prog – this is an array of colored boxes, one for eachprogram. The color codes are common for programs andvalves and a color key has been included to the right.MV – this set of boxes represents the state of each of thefour possible master valvesZones – the array of zone status boxes show fifty zones at atime, with the default being zones 1 to 50. To see the nextPage 55Baseline 3200