BaseStation 3200 User Manual - Baseline Systems

C h a p t e r 5 – R e f e r e n c eblock of fifty zones, press the + key. The + and – keys can be used to navigate amongeach block of fifty zones.There are several additional status screens that are available with the dial in this position. Theycan be accessed using the NEXT/PREV keys.Detailed Program Status – this screenshown to the right shows someadditional information aboutprogram A. For convenience, themainline assignment is also indicatednext to the program letter. While onthis screen, the other programs canbe viewed by pressing the + key toscroll through each of the statussummaries. Pressing the NEXT keywill move to the next status category.Moisture biSensor Chart – each ofthe biSensors in the system can beviewed in a two week chart showingthe moisture levels for four intervalsduring each day. Also indicated onthe chart is either the upper or lowerlimit. The lower limit is indicated bya green line (start watering) and theupper limit is shown by a red line(stop watering). The biSensor serialnumber is displayed at the bottom ofthe graph and the current moisturereading is displayed along the top.Use the + or – keys to change thebiSensor being displayed. Pressingthe ENTR key will change the verticalmoisture graph range to higher orlower moisture ranges can be seen.Press the NEXT key to move to thenext status screen.Flow Device Status – these screensprovide information about waterused as measured by the flow device,as can be seen in the sample screento the right. There is a screen foreach of the flow devices configured inthe system. Use the + or – keys toscroll between each of the flowdevice status screens. Press the NEXTkey to move to the next statusscreen.Pause Status Screen – this screen isonly available when there is an activepause or controller stoppedcondition. If there are multiple pausePage 56Baseline 3200