Printrex 980 Operator's Guide - TransAct

How to Operate the Printrex ® 980 Printer5. Move the printer.Note: To move the printer on the same floor or within the same building, the inktanks need not be removed. If the ink tanks are removed before movingthe printer, ink can leak from the needle sections in the ink tank slots,which may stain clothes and/or the surrounding work area. Always hold the printer level and carry it slowly. If ink is spilled inside theprinter while moving it, this could cause a fire or serious electrical shock ordamage the printer. The printer weighs about 123 pounds (57kg). Three persons are alwaysrequired to move the printer. When lifting and moving the printer, theyshould hold the handles at the bottom so that they do not injurethemselves. If they hold other parts of the printer, the printer can bedamaged and/or it can drop and injure people. Do not move the printer with the upper unit, ink tank door, or maintenancecartridge door open. This can damage the printer.6. After moving the printer to the destination, connect the power cord and thenconnect the interface cable.7. Turn on the main power switch.100-11672 - Rev D Page 107