Printrex 980 Operator's Guide - TransAct

Appendix A: Ordering Genuine Ithaca SuppliesCode Detail Code Item Description2. Replace Encoder Sensor.3. Replace Operation Panel PCB.4. Replace DC Power PCB Unit.01 07 Condition Motor 24V was not turned OFF correctlyDetectedAction 1. Replace DC Power PCB Unit.2. Replace Printer Controller PCB.01 08 Condition Printhead 5V was not turned OFF correctlyDetectedAction 1. Replace DC Power PCB Unit.2. Replace Printer Controller PCB.01 09 Condition Printhead 24V was not turned OFF correctlyDetectedAction 1. Replace DC Power PCB Unit.2. Replace Printer Controller PCB.01 0A Condition VHTM of the fuse to be blownDetectedAction1. Replace DC Power PCB Unit.2. Replace Printer Controller PCB.01 Remarks For Detail Codes 05 to 09, the occurrence of the error isstored inmemory, so the same error will recur next time Printer starts.Toclear the error, (Service Utility > Parts Replacement > ReleasetheError) and then restart Printer.02: Power Supply Error02 11 ConditionDetectedPrinter Controller PCB 3.3V was not turned ONcorrectly.Replace DC Power PCB Unit.Motor 24V was not turned ON correctlyAction02 13 ConditionDetectedAction Replace DC Power PCB Unit.02 14 Condition Printhead 5V was not turned ONcorrectlyDetectedAction Replace DC Power PCB Unit.02 15 Condition Printhead 24V was not turned ON correctlyDetectedAction Replace DC Power PCB Unit.02 Remarks For Detail Codes 11 to 15, the occurrence of the error isstored in memory, so the same error will recur next timePrinter starts. To clear the error, (Service Utility > PartsReplacement > Release the Error) and then restart Printer.05: Printhead Position Error05 20(MODULE1)A0(MODULE2)ConditionDetectedActionPrinthead position error1. Check Printhead Lifter part movement.2. Replace Print Module.100-11672 - Rev D Page 185