Printrex 980 Operator's Guide - TransAct

Appendix A: Ordering Genuine Ithaca SuppliesAdjustmentAdjustment When Replacing PartsThis section describes the works to be carried out, as an after-sale service,after parts replacement.Target Parts Adjustment Item Reference section in manualPrint Module Print Modules in "Work at Print Module Replacement"placeInput of various "Print Module Replacement Procedure"adjustment values(*1) (Indicated onlabels)Head position (*2) "Head Position Adjustment"Printhead Head position (*2) "Head Position Adjustment"Purge Unit Blade position "Blade Position Adjustment"Input of Purge Unitwipe position"Consumable Parts ReplacementProcedure"(Indicated on label)Transport Unit Pinch Roller position "Pinch Roller Position Adjustment"Head position (*2) "Head Position Adjustment"Backfeed gap "Backfeed Gap Adjustment"Rack Unit Rack position "Work at Rack Unit Replacement"Lift Unit / RearFeeder sensorStacker Rail /Front TrayUnitPrinterControllerPCBDC PowerSupply PCBRear Feeder sensorFront Tray UnitIn the case data canbe retrieved (Sendthe data to Printer )In the case data canbe retrieved (serialnumber, time, variousadjustment values(*1), Rear FeederSensor, ink ejectpower, Printheadposition, backfeedgap)Ink eject power"Rear Feeder Sensor Adjustment""Work at Stacker Rail and/or Front TrayUnit Replacement""• In the case data can be retrieved fromPrinter Controller PCB to PC.""• In the case data cannot be retrievedfrom Printer Controller PCB to PC.""DC Power Supply Unit ReplacementProcedure"(*1) Printhead wipe position, Printhead capping position, Printhead printposition, and Purge Unit wipe position(*2) T-K gap, slant, and Head position(*3) Use adjustment tool (supplied with service parts).100-11672 - Rev D Page 137