Printrex 980 Operator's Guide - TransAct

Appendix A: Ordering Genuine Ithaca SuppliesSpur Marks (White Dotted Lines)Cause Procedure Check Item ActionPaper 1 Dedicated paper is not used. Replace withdedicatedpaper.Spur Unit 2 The unit is not installed properly. Reinstall itproperly.3 Spur does not rotate smoothly. Replace SpurUnit.TransportUnit4 Transport Belt is not located at thecorrect position.5 Replace Transport Unit, and then checkthat the defect has been recovered.Move TransportBelt back to thecorrect position.Ink Smearing (Due to Printhead Crash)Cause Procedure Check Item ActionPaper 1 Paper leading edge is folded or curled. Correct the foldor curl.Pinch RollerUnit or SpurUnitEnd2 The unit is not installed properly. Reinstall itproperly.3 Pinch Roller or Spur does not rotatesmoothly.Replace PinchRoller Unit orSetup 4 The Printhead height adjustment valueand Paper Suction Fan adjustment valueare not set.Ink SupplySystem5 Even when Medium Cleaning is carriedout, waste ink is not sucked from PurgeUnit.Spur Unit.Set Printheadheightadjustmentvalue andPaper SuctionFan adjustmentvalue.After replacingPump Unit,carry outMediumCleaning.Purge Unit 6 Blade, Cap, or Cap Base is deformed. After replacingPurge Unit,carry out LightCleaning,MediumCleaning, andStrongCleaning.Printhead 7 Replace Printhead, and then check thatthe defect has been recovered.End.Print Module 8 Print Module is not installed properly. End.9 Replace Print Module, and then checkthat the defect has been recovered.End.100-11672 - Rev D Page 135