wind energy resource evaluation in a site of central italy ... - WindSim

More documents

Recommendations

Info

Figure 5.13: Speed-2D at 30 m height for sector 270 and velocity 5, 10, 20 m/s.89
CHAPTER 6. Analysis of the wind field over the site.6.1 IntroductionIn this chapter a series of CFD simulations of the wind flow over a complex site incentral Italy has been carried out. Different boundary condition, corresponding todifferent direction of the wind rose have been employed. The results of this CFDanalysis are used to perform a cross checking procedure of the experimental winddata.The geometrical model used in the simulations encloses the entire site and wasresolved with a grid able to guarantee accurate results, as shown in chapter 5.The cross checking procedure has been conducted by using the transferredclimatology object, included in the WindSim software. As described in chapter 1,when multiple measurement masts are available in one site, it is possible to predictthe wind resources in one measurement station using data available in the othermeasurement station. The comparison between experimental and CFD data can bedone by producing graphs and calculating RMS errors to evaluate the accuracy ofthe results. Velocity vertical profiles and turbulence intensity vertical profiles havebeen also calculated and analyzed.6.2 Geometrical modelThe geometrical domain is based on a unique model to solve the Wind Field. Arefinement of the major interest zone has been created, containing the plateauwhere the two measurement masts are located.The characteristics of the geometrical model are shown in the table 6.1.90
Page 1 and 2:
UNIVERSITÀ DEGLI STUDI DI CAGLIARI
Page 3 and 4:
IndexIndex page IAcknowledgmentsVII
Page 5 and 6:
CHAPTER 4: Characteristics of the s
Page 7 and 8:
6.7.1 Mean wind velocity page 1096.
Page 9 and 10:
This thesis is the result of a prac
Page 11 and 12:
WindSim is a software developed by
Page 13 and 14:
CHAPTER 1. Atmospheric Boundary Lay
Page 15 and 16:
Figure 1.1: Example of an atmospher
Page 17 and 18:
1.5 The WindSim numerical codeWindS
Page 19 and 20:
(κ−ε RNG or the Low Reynolds),
Page 21 and 22:
1.5.4 RESULTSThe Results module all
Page 23 and 24:
Figure 1.2: Example of TKE vertical
Page 25 and 26:
CHAPTER 2. Simulations over flat te
Page 27 and 28:
inlet position (0 meters), station
Page 29 and 30:
2.4 Height distribution factor sens
Page 31 and 32:
e decreased, to avoid to build thin
Page 33 and 34:
Figure 2.10: Vertical profiles for
Page 35 and 36:
CHAPTER 3. Simulations over 2D hill
Page 37 and 38:
Table 3.1: Measurement coordinatesS
Page 39 and 40:
The results shown above demonstrate
Page 41 and 42:
Figure 3.6: Sketch of the 15 km lon
Page 43 and 44:
Figure 3.9: Influence of the height
Page 45 and 46:
Figure 3.13: Zoom of the hill top r
Page 47 and 48: 3.5.2) = ∙.The two models for att
Page 49 and 50: H [m] hill heightν[m 2 /s] air cin
Page 51 and 52: Figure 3.18: Particular of the nume
Page 53 and 54: Finally, the horizontal x velocity
Page 55 and 56: Figure 3.25: Z velocity componentFi
Page 57 and 58: 3.6 RemarksA CFD study of a boundar
Page 59 and 60: Some experimental wind data of this
Page 61 and 62: Both the pictures 4.3 and 4.4 have
Page 63 and 64: Table 4.2: Description of the color
Page 65 and 66: In this periods, data are recorded
Page 67 and 68: In the following pages, a short des
Page 69 and 70: 4.3.2 Mast 5424-15 m Period April-M
Page 71 and 72: 4.3.4 Mast 5424-15 m Period Novembe
Page 73 and 74: 4.3.6 Mast 5428-40 m Period April-M
Page 75 and 76: 4.3.8 Mast 5428-50 m Period Novembe
Page 77 and 78: 4.3.10 Mast 5428-30 m Period Novemb
Page 79 and 80: 4.4.2 Mast 542870
Page 81 and 82: 4.5.2 Mast 542872
Page 83 and 84: CHAPTER 5. Test of the Free Stream
Page 85 and 86: case the wind is blowing from the e
Page 87 and 88: Geometrical modelTable 5.3: Input p
Page 89 and 90: Figure 5.6: Vertical profiles in po
Page 91 and 92: The orthogonalization of the grid h
Page 93 and 94: Figure 5.9: Map of speed-ups for di
Page 95 and 96: Figure 5.30: Speed-2D at 30 m heigh
Page 97: Figure 5.12: Speed-2D at 30 m heigh
Page 101 and 102: Table 6.2: Boundary conditions and
Page 103 and 104: 6.5 Vertical profiles of VelocityTo
Page 105 and 106: characterized by high wind speed (5
Page 107 and 108: From the error analysis, it is foun
Page 109 and 110: Anyhow, the trend of the linear int
Page 111 and 112: Concerning the CFD simulations, val
Page 113 and 114: Analyzing RMS error table for tower
Page 115 and 116: A general overview of the figure 6.
Page 117 and 118: 6.7 Cross Checking of wind dataIn t
Page 119 and 120: Figure 6.8 a/bFigure 6.8 c/dFigure
Page 121 and 122: Table 6.11: RMS error for cross che
Page 123 and 124: Figure 6.9 e/fFigure 6.9 g/hFigure
Page 125 and 126: Figure 6.10 g/hFigure 6.10 i/lFigur
Page 127 and 128: to have a better agreement during t
Page 129 and 130: Figure 7.2: Weibull fitting of the
Page 131 and 132: Figure 7.5: Perspective view of the
Page 133 and 134: The calculated AEP has been reporte
Page 135 and 136: ConclusionsIn this thesis the evalu
Page 137 and 138: Bibliography[1] CRASTO G. - Numeric
show all

wind energy resource evaluation in a site of central italy ... - WindSim

Create successful ePaper yourself

Delete template?

Save as template?