CLP-170 CLP-150 - Yamaha

Message List
(CLP-170)
(CLP-170)
100 CLP-170/150
Message Meaning
1. This message will appear if a problem is found with the song data
when you select a song or while the song is playing. In this case, reselect
the song, and try once again to play it back. If the message
still appears, the song data may have been damaged.
2. This message will appear if a different “CharacterCode” (page 54)
is selected than when you assigned the song name. In this case,
switch the “CharacterCode”, re-select the song, and play back.
1. This message will be displayed if current memory fills up during
recording. Recording will stop automatically at this point. The
data that had been recorded up to that point will remain. This
message will also be displayed when you attempt to enter Record
mode for additional recording if that song already occupies all of
current memory. In this case, additional recording will not be possible.
If there is an already-recorded track that you do not need to
keep, you can use “ChannelClear” (page 74) to delete the
unneeded track, so that you will then be able to record the equivalent
amount of additional material.
2. This message will be displayed when you select a song if that song
is larger than the capacity of the current memory (page 102). This
song cannot be loaded into the CLP-170/150, and cannot be
played back. Please select a different song.
This message will be displayed when you edit a song if that song is
larger than the capacity of the current memory (page 102). This
song cannot be edited on the CLP-170/150.
This message prompts you to start the operation. To start, press the
B [+ (YES)] button. Press the [EXIT] button to cancel the operation.
This message prompts you to confirm the execution. Press the
B [+ (YES)] button to continue. Press the B [– (NO)] button to cancel.
You tried to perform a file- or disk-related operation using an unformatted
disk. Eject the disk, format it using the “FormatDisk” parameter
(page 53), and try again.
You tried to perform a file- or disk-related operation using an unformatted
disk. To cancel the operation, press the B [– (NO)] button.
To format the disk and try again, press the B [+ (YES)] button to
display the “FormatDisk” parameter (page 53).