CLP-170 CLP-150 - Yamaha

Detailed settings for the voices [VOICE SETTING]
80 CLP-170/150
Setting the chorus on/off
[ChorusOnOff]
You can set the [CHORUS] button on or off for
each voice. When you select a voice, the chorus on/
off setting for the voice automatically changes
according to this parameter.
TIP
Even if this parameter is turned on, the chorus effect is
disabled if the ChorusSend parameter is set to 0.
See the procedure on page 71.
Setting range:
On/Off
A
C
Selecting the DSP type*
[DSP Type (DSP)]
You can select other effects (than reverb and chorus).
See the procedure on page 71.
A
C
Setting range:
DelayLCR Delay applied at left, center, and
right positions.
DelayLR Delay applied at left and right
positions.
Echo Echo-like delay
CrossDelay Left and right delays are crossed.
Symphonic Adds a rich and deep acoustic
effect.
RotarySpeaker Adds the vibrato effect of a rotary
speaker.
Tremolo The volume level changes in
rapid cycles.
VibeRotor The vibrato effect of a vibraphone.
B
NO YES
D
B
NO YES
D
AutoPan The sound pans left to right and
back and forth.
Phaser The phase changes periodically,
swelling the sound.
AutoWah The center frequency of the wah
filter changes periodically.
SoundBoardRev Simulates the reverberation of a
piano soundboard.
Off No effect.
Setting the speed of the vibraphone
vibrato effect* [VibeRotorSpeed]
TERMINOLOGY
Rotor= The rotating portion of an electrical device etc.
This will be displayed only if VibeRotor is selected
for the DSP Type parameter explained above.
This sets the speed of the vibrato effect that is
applied when you have selected Vibraphone and
are using the VibeRotor pedal.
See the procedure on page 71.
Setting range:
1–10