Dolphin 9700 User's Guide Rev (a) - Finn-ID

R&TTE Compliance Statement—802.11a/b/g, Bluetooth, and/or GSMDolphin RF terminals are in conformity with all essential requirements of the R&TTE Directive (1999/5/EC).This product is marked with in accordance with the Class II product requirements specified inthe R&TTE Directive. In addition, this product complies to 2006/95/EC Low Voltage Directive whensupplied with the recommended power supply. Honeywell shall not be liable for use of our product withequipment (i.e., power supplies, personal computers, etc.) that is not CE marked and does not complywith the Low Voltage Directive.The equipment is intended for use throughout the European Community; PAN European FrequencyRange: 2.402–2.480 GHz. Restrictions for use in France are as follows:• Indoor use: Maximum power (EIRP*) of 100 mW for the entire 2.400–2.4835 GHz• Outdoor use: Maximum power (EIRP*) of 100 mW for the 2.400–2.454 GHz band & maximum power(EIRP*) of 10 mW for the 2.454–2.483 MGHz band.• 5Ghz band: UNII (Unlicensed National Information Infrastructure) or band1 (5.150 to 5.250 GHz) isrestricted to indoor use only. Any other use will make the operation of the device illegal.For further information, please contact:Honeywell Scanning & Mobility Europe BVNijverheidsweg 95627 BT EindhovenThe NetherlandsDolphin RF Terminal—802.11a/b/g, Bluetooth, and/or GSMThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.If necessary, the user should consult the dealer or an experienced radio/television technician foradditional suggestions. The user may find the following booklet helpful: “Something About Interference.”This is available at FCC local regional offices. Our company is not responsible for any radio or televisioninterference caused by unauthorized modifications of this equipment or the substitution or attachment ofconnecting cables and equipment other than those specified by our company. The correction is theresponsibility of the user. Use only shielded data cables with this system.In accordance with FCC 15.21, changes or modifications not expressly approved by the party responsiblefor compliance could void the user’s authority to operate the equipment.Caution! Any changes or modifications not expressly approved by the grantee of this device could voidthe user's authority to operate the equipment.1 - 3