Dolphin 9700 User's Guide Rev (a) - Finn-ID

Establishing CommunicationThe RS232 interface allows the terminal to communicate to a workstation, modem, or any standardRS232 device using a standard serial cable and communications software.RequirementsYou need the following equipment:• A Mobile Base device powered by a power cable and power adapter cable• The RS232 communications cable• ActiveSync v4.5 or above on the host workstation• Windows ® 98 Second Edition*, Windows ® Me, Windows ® 2000, or Windows ® XP on the hostworkstationConnecting the Communication CablesNote:You must be using ActiveSync 4.5 or higher.1. Plug in the power supply and connect it to the bottom of the base.2. Plug the RS232 communication cable into the bottom of the base.3. Connect the communication cable into the back of the workstation.4. At this point, the hardware is installed and operating.You may need to reboot your workstation to complete the installation process.Establishing ActiveSync CommunicationThe Dolphin terminal is usually auto-detected and configured by ActiveSync based on the communicationcable. If you are using an RS232 cable, ActiveSync will usually set up an RS232 connection.For more details, see ActiveSync Communication on page 8-8.Connecting the CablesConnect the base to the host workstation or other device by plugging an RS232 serial cable into theRS232 Communications Port on the bottom of the base. Plug the other end of the RS232 serial cable intothe correct port on the host RS232 device.The wiring of your cable depends on whether the other device is set up as a Data CommunicationsEquipment (DCE) or Data Terminal Equipment (DTE) device.The Communication Port is configured as a DCE device. To communicate with a DTE device such as aworkstation, use a standard (or straight-through) RS232 cable. To communicate with a DCE device, useeither a null modem adapter in line with a standard RS232 cable, or a null-modem serial cable.13 - 7