Technical details System pro M compact®

Systempro M compact ®Technical detailsAccessories for measurementinstrumentsMeasurementdevicesTRANSDUCERS FOR POWER FACTOR METERSTechnical characteristics2CSC445093F0001Separated auxiliary supply [V] a.c. 230/400Input rated values [V] a.c. 230/400 (5 A)Output rated values (selectable)1, 5, 10 V d.c.1, 5, 10, 20, 4/20 mA d.c.Ohmic load [Ohm] 700Measurement fi eld0÷Pn (0÷Qn)Conversion typeproportional to phase angle or to cosϕAccuracy rating 0.5Permanent overload2 In/1.2 UnInstantaneous overload10 In/2 Un for 1 sec.Operating frequency [Hz] 50/60Time delay [ms] 300Alternated residue 1%Self-consumptionvoltage=1 VA/curr.=0.8 VA/aux. supply=4 VAInput/output galvanic separationinput/output insulation, aux. supply 2 kV for 1 min./50 Hzcircuit/mass insulation 4 kV for 1 min./50 HzOperating temperature [°C] 0...55Dimensions6 DIN modulesWeight [kg] 0.49Single-phase line and input and output selection10 V d.c.5 V d.c.1 V d.c.4÷20 mA d.c.20 mA d.c.10 mA d.c.5 mA d.c.1 mA d.c.1 mA d.c. (analogue signal)230 VCThe output selection must be performed by movingthe programming pushbuttons according to thespecific needs.SELECTABLE OUTPUTS- + + -N13 14 16 17 1923 24If a V output has been selected it is necessary toconnect terminals 13 and 14, while for mA outputsthe terminals 16 and 17 must be connected. Forsupplying the device at 230 V connect the commonterminal “C” and the terminal 23.Pushbutton for signal switch1 2 8Leftproportional to the cosϕ.11L1NS1P15 AS2P2VRightProportional to the phaseangle (output in grades, forinsertion with analogue reading instrument).Connect input voltage to terminal 8.Connect input current to terminals 1 and 2.2CSC445013F090111/110 ABB