Vivotek FD8162 Fixed Dome Network Camera User Manual - Use-IP

POWER CO LISION1 2 3 4 5LINKRECEIVEPARTITIONVIVOTEKNetwork DeploymentSetting up the Network Camera over the InternetThere are several ways to set up the Network Camera over the Internet The first way is to setup the Network Camera behind a router The second way is to utilize a static IP The third way isto use PPPoEInternet connection via a routerBefore enabling the access to the Network Camera over the Internet, make sure you have arouter and follow the steps below1 Connect your Network Camera behind a router, the Internet environment is illustrated belowRegarding how to obtain your IP address, please refer to Software Installation on page 12 fordetailsInternetWAN (Wide Area Network )Router IP address : from ISPIP address : 192.168.0.3Subnet mask : 255.255.255.0Default router : 192.168.0.1LAN (Local Area Network)Router IP address : 192.168.0.1Cable or DSL ModemIP address : 192.168.0.2Subnet mask : 255.255.255.0Default router : 192.168.0.12 In this case, if the Local Area Network (LAN) IP address of your Network Camera is19216803, please forward the following ports for the Network Camera on the router■ Secondary HTTP port■ RTSP port■ RTP port for audio■ RTCP port for audio■ RTP port for video■ RTCP port for videoIf you have changed the port numbers on the Network page, please open the ports accordinglyon your router For information on how to forward ports on the router, please refer to yourrouter’s user’s manual3 Find out the public IP address of your router provided by your ISP (Internet Service Provider)Use the public IP and the secondary HTTP port to access the Network Camera from theInternet Please refer to Network Type on page 51 for details10 - User's Manual