Vivotek FD8162 Fixed Dome Network Camera User Manual - Use-IP

VIVOTEKAuto: If you set Exposure mode as Auto, the Exposure time and Gain control will be not configurablesince the sensor library will automatically adjust the value according to the ambient light Then you canset iris mode as "indoor" or "outdoor" to reach the best image qualityYou can click Preview to fine-tune the image, or click Restore to recall the original settings withoutincorporating the changes When completed with the settings on this page, click Save to enable thesettingsIf you want to configure another sensor setting for day/night/schedule mode, please click Profile to openthe Profile settings page as shown below.2011/03/13 17:08:56Please follow the steps below to setup a profile:1 Check Enable and apply this profile2 Select the applied mode: Day mode, Night mode, or Schedule mode Please manually enter a rangeof time through which you want the Schedule mode to apply3. Configure Exposure control settings in the folowing columns. Please refer to the previous page fordetailed information4 Click Save to enable the setting and click Close to exit the page76 - User's Manual