Download Glorystar Installation Guide - Free Christian Satellite ...

More documents

Recommendations

Info

40LNBF Rotation SettingSet the LNBF Rotation (Skew Angle) to thesetting specified in the aiming instructionsprovided with your system. The LNBF rotates inthe circular clamp until the centering line on thetop of the LNBF aligns with the LNBF Rotationangle. Each mark indicates 5 degrees.LNBF Rotation: ___________(Skew)Example: Positive +20°When standing in front of the dish andlooking at the back of the LNBF andtowards the reflector, rotate the LNBFcounter clockwise (left) for a positive(+) LNBF Rotation (Skew) setting andClockwise (right) for a negative (-) LNBFRotation (Skew) setting.Dish AimingElevation AngleSet the Dish Elevation to the angleprovided on the cover of this manual.The pointer for the elevation indicatoris a white line that is visiblethrough the elevation scale andis located near the edge of theelevation fastening nut.Elevation Angle: ___________B. Gohl © GEOSATpro
When setting the elevationangle on an offset dish, it isimportant to note that the dish willappear be aimed lower than theactual elevation angle to the satellite.The scale on the elevation bracket iscalibrated for accurate aiming whenthe post is installed perfectly plumb(leveled on all sides). The dish elevationangle cannot be found using the anglefinder on the LNBF arm or on the faceof the dish.41Do not grip the edges of the reflector to adjust the dish. Alwayshold the dish by the elevation bracket during elevation or azimuth(side-to-side) adjustments. Applying pressure to the edges of thereflector will affect the accuracy of the satellite signal reflectionfrom the dish into the LNBF.Semi-tighten the elevation fastening nuts to hold the dish in position.Do not tighten the fasteners for final setting at this time. Additionaladjustment will be needed to locate and peak the satellite signal.Compass Reading: AzimuthIn North America, satellites are always located South of your location.To correctly aim the dish you must first accurately determine theexact compass reading angle (azimuth). Metals, electricity and othermagnetic disturbances can cause the compass to point incorrectly.Compass readings should be made at least 10 feet in front of orbehind the metal satellite dish and away from any large metal objectsuch as metal buildings, air conditioners, vehicles, utility and powerlines or electrical panels. Check compass reading several times toreduce install time and the need to hunt the entire southern sky forthe satellite signal.www.geosatpro.com Toll <strong>Free</strong> 888-483-4673
Page 2 and 3: Owners ManualInstallation GuideVers
Page 5 and 6: Important Safeguardswww.geosatpro.c
Page 7 and 8: DSR200c / DVR1100c SpecificationsMP
Page 9 and 10: Rear Panel12345678910111213Connects
Page 11 and 12: Remote Key Functions DSR200c / DVR1
Page 13 and 14: Receiver Operation Guide11Program I
Page 15 and 16: Stereo or Mono Audio Selectiona) Pr
Page 17 and 18: Receiver Menu ItemsPress MENU butto
Page 19 and 20: www.geosatpro.com Toll Free 888-483
Page 21 and 22: 1. Press RED button to exit - no mo
Page 23 and 24: 21Highlight Control Panel. Press OK
Page 25 and 26: Highlight USB. Press OK.This menu s
Page 27 and 28: 25V-1. Time Machine - DVR1100cTime
Page 29 and 30: 27Timer - DVR1100cIf no event infor
Page 31 and 32: Installation Guides29This guide is
Page 33 and 34: Site Survey31If you feel comfortabl
Page 35 and 36: 33How High Up in the Sky is the Sat
Page 37 and 38: Dish Assembly35Once a dish location
Page 39 and 40: 37Attach the LNBF Arm to the Elevat
Page 41: Center the bubble in the level then
Page 45: Connect Receiver to a TVThe easiest
Page 48 and 49: 46The Glorystar receiver will autom
Page 50 and 51: 48Press the CH/DOWN arrowbutton on
Page 52 and 53: 50Two Room Install - (optional)Do n
Page 54 and 55: 527. Press the RIGHT arrow to selec
Page 56 and 57: 54Using Satellite MetersInexpensive
Page 58 and 59: 56FAQ - Frequently Asked QuestionsH
Page 60 and 61: 58FAQ - DVR1100c - cont.USB drive m

Download Glorystar Installation Guide - Free Christian Satellite ...

Create successful ePaper yourself

Delete template?

Save as template?