Download Glorystar Installation Guide - Free Christian Satellite ...

Carefully route the coax cable fromthe dish to the ground block thento the satellite receiver. Secure allcables using appropriate cable clipsand nylon zip ties. Avoid usingwire staples as they can dimple orpenetrate the cable and can causeloss of signal! Form drip loops andcable loops as needed to preventwater from running down the cables and entering cable connectionfittings or into wall penetrations. Remember to seal all exterior walland/or roof holes with a quality sealant or silicone caulking.Install the grounding block andwire while observing all NEC,National Electrical Code and localcodes. Connect the ground wire tothe structure ground. If you areunsure of how to properly groundyour satellite system, pleaseconsult with a local professional.Copies of the NEC are available atyour local library or online.Important Notice: GEOSATpro recommends that you DO NOTuse existing coaxial cabling that has been pre-wired or previouslyused in your home. Often these cables are low quality RG-59, notrated for satellite applications or have splitters and other devicesthat are not compatible. Always connect the RG-6 type coax cabledirectly from the satellite dish LNBF through the grounding blockand attach to the LNBF IN Digital connection on the rear of theSatellite Receiver.Cable splitters and other devices in the coax line may cause thesatellite receiver to shut down or malfunction. Do not use any devicein the coax line unless approved for satellite installation. Multiplereceiver installations must use a multiple output LNBF to avoidtuning conflicts between the receivers. Splitters will not work!www.geosatpro.com Toll Free 888-483-467355Completing the Install and Grounding