Vertex VXA 710 Transceiver - Pilot Supplies

Precautions This apparatus is capable of two-way communicationon channels used for critical aviation safety communications.Therefore, it is important that this radio bekept away from children or other unauthorized usersat all times. When making DC connections via the (optional) E-DC-5B DC cable, be absolutely certain to observethe proper voltage level and polarity guidelines. Donot connect this radio directly to any 24 ~ 28 Volt DCsource, nor to AC power of any kind. Connecting theVXA-710 directly to a source which exceeds 15.0Volts DC will result in damage to the unit. Do not dispose of the LI-ion Battery Pack in a fire.Do not carry a LI-ion Battery Pack in your pocket,where keys or coins could short the terminals. Thiscould create a serious fire/burn danger, and possiblycause damage to the LI-ion pack.BEFORE YOU BEGINHow to Install the Quick Draw Belt Clip Connect the hanger to the rear of the VXA-710, withthe notch pointing directly up, using the supplied screw(Figure 1). Use only the screw included with the clipto mount the clip to the back of the VXA-710! Clip the Quick-Draw Belt Clip onto your belt (Figure2). To install the VXA-710 into the Quick-Draw Belt Clip,align the hanger with the Quick-Draw Belt Clip, andslide the VXA-710 into its slot until a click is heard(Figure 3). To remove the VXA-710 from the Quick-Draw BeltClip, rotate the VXA-710 180 degrees, then slide theVXA-710 out from the Quick-Draw Belt Clip (Figure4).Figure 18Figure 2 Figure 3 Figure 4VXA-710 SPIRIT OPERATING MANUAL