TO 00-20-14 30 SEPTEMBER 2011 - Wright-Patterson Air Force Base

TO 00-20-14 30 September 20115.4.2.6.2 Interval with Operating Hours. In cases where the calibration interval is based on either a specified interval ora number of operating hours, enter the date the item would be due for recalibration under the specified interval and theoperation hours.5.4.2.6.3 Absolute standard or ICO. Enter ABS or ICO instead of a date, as applicable.5.4.2.6.4 WRM or CEE. Leave this block blank if the TMDE will be packed or stored as WRM or CEE. Once the itemis removed from the WRM/CEE package or storage, the user shall annotate their TMDE inventory listing and thecertification label with the new due date. User shall also notify the PMEL of the new date due. The calibration due dateshall be computed using the assigned calibration interval starting from the date the TMDE is removed from the WRM orCEE status.5.4.2.6.5 SICW. For SICW items, this block will match the Date Due block of the end item certification label.5.4.3 AFTO FORM 108, TMDE Certification Label. An AFTO Form 108 (see Figure 5-4) can only be used if allspecifications of the calibration authority are met. The calibrating technician or other authorized person shall fill out thislabel as described in the general instructions or in the following manner, as applicable.IDENTIFICATION NO.AUTHORITY (T 0., ETC)PREVIOUS EDITION WILL BE USEDAFTO FORM 108 Nov 84SPECIALCERTIFIED BYDATE CALIBRATEDDATE DUECERTIFIED BYDATE CALIBRATEDDATE DUETMDE CERTIFICATIONFigure 5-4. AFTO FORM 108, TMDE Certification Label (White).5.4.4 AFTO FORM 394, TMDE Certification Label. AFTO Form 394 (see Figure 5-5) can only be used if allspecifications of the calibration authority are met. The calibrating technician or other authorized person shall fill out thislabel as described in the general instructions.CERTIFIED BYTMDE CERTIFICATIONID.NO.SPECIALDATE CAL DATE DUEAFTO FORM 394, MAR 86PREVIOUS EDITION WILL BE USEDFigure 5-5. AFTO FORM 394, TMDE Certification Label.5.4.5 AFTO FORM 99, Limited/Special TMDE Certification Label. The yellow AFTO Form 99 (see Figure 5-6) is usedfor standards and TMDE certified with a limited or special calibration as defined in Section 3 of this TO. Also, certain33K TOs may direct use of this label because they do not verify all, or portions of, main functions and ranges. It is theresponsibility of the user to read and apply whatever is in the SPECIAL block. This label shall also be used forequipment designated as NHA, NPC or CBU. The calibrating technician or other authorized person shall fill out thislabel in the following manner and as described in the general instruction, as applicable.5-6