TO 00-20-14 30 SEPTEMBER 2011 - Wright-Patterson Air Force Base

30 September 2011 TO 00-20-145.12.2 AFMETCAL PORTION Blocks. AFMETCAL personnel shall complete the following blocks:a. AFMETCAL CONTROL #. Enter the applicable control number.b. OPR ORG. Enter the organizational symbol for AFMETCAL office that shall serve as OPR for this request.c. OPR NAME / PHONE / EMAIL. Enter the name, DSN or commercial telephone numbers, and email address ofthe person that shall be OPR for this request.d. DATE RECEIVED. Enter date received by the OPR ORG.e. RESPONSIBILITY DETERMINATION. Check the block or fill in the responsibility determination.f. NEW PROCEDURE REQUIRED. Check the appropriate block.g. WUC IS. Enter the assigned WUC.h. CALIBRATION INTERVAL IS. Enter the initial calibration interval for this part number or model.i. CALIBRATION AUTHORITY IS. Enter the calibration authority if calibrated.j. MAINTENANCE MANUAL IS. Enter one, if one exists. It may provide useful data.k. REMARKS. This block is used to explain rationale behind the entry in one of the previous two blocks. Givespecific reasons why a determination cannot be made or explain why a specific determination was made.l. ITEM. Check appropriate blocks.m. NON-TMDE. Check if item is not TMDE according to definition in TO 00-20-14 and is not PMELresponsibility. If this block is checked, the item under consideration is the responsibility of the USER forsupport.n. SUPERVISOR. Written name of supervisor of person called out above.o. RESPONSE DATE. Enter the date the calibration responsibility determination is made.5-13