TO 00-20-14 30 SEPTEMBER 2011 - Wright-Patterson Air Force Base

30 September 2011 TO 00-20-145.13 AFTO FORM 57, PMEL TECHNICAL ORDER INFORMATION.The AFTO Form 57 (see Figure 5-11) is for the PMEL to record data relative to a calibration procedure that pertains totheir peculiar situation. It shall be filed in the folder holding the pertinent calibration TO. This form is not required witheach TO. It is to be completed to the degree (and when) PMEL personnel feel is necessary or as needed. Also, it shallnot be used in place of AFTO Form 22 action. The following guidance is provided for entries on this form:NOTEThe technician shall verify information entered on the AFTO Form 57 prior to usingsuch information.a. Block 1, MAINTENANCE TO INFORMATION. Enter the part number and maintenance TO for the differentmodels or part numbers covered by the procedure in the appropriate blocks.b. Block 2, ADDITIONAL ITEMS REQUIRED FROM THE OWC. Enter any additional ancillary items orequipment that must be supplied by the OWC to facilitate repair or calibration of the TMDE entered in Block 1.c. Block 3, LOCATION OF TEST FIXTURES. Enter the PMEL storage location of test fixtures required forrepair or calibration of the TMDE entered in Block 1.d. Block 4, SUITABLE SUBSTITUTES FOR STANDARDS REQUIRED IN CALIBRATION PROCEDURES.Enter the part number of all TMDE listed in the procedure that is not locally available and the part number of thesubstitute standard in the appropriate blocks.NOTEEnsure required uncertainty ratios are maintained when substituting standards duringcalibration.e. Block 5, AFTO FORM 22 INFORMATION. Enter all AFTO Form 22 information as necessary to identifydeficiencies in the procedure. Enter date submitted, paragraph affected, and name of technician submitting theAFTO Form 22 as a minimum.NOTEApproval of an AFTO Form 22 is not justification to deviate from published technicaldata IAW TO 00-5-1.f. Block 6, ALTERNATE PROCEDURE INFORMATION. Enter any information that shall allow the technicianto locate or perform approved alternate procedures.g. Block 7, PECULIARITIES OF TMDE OR CALIBRATION PROCEDURE. Enter any information that willassist the technician during calibration of the TMDE.h. Block 8, HIGH FAILURE COMPONENTS. Enter any components that are considered high failure items orcomponents that are difficult to identify (Part Number and NSN) in the appropriate blocks.5.13.1 Continuation Sheets. Continuation sheets can be attached as necessary.5-15