TO 00-20-14 30 SEPTEMBER 2011 - Wright-Patterson Air Force Base

TO 00-20-14 30 September 20115.4.6.4 INI Block. The representative designated IAW Paragraph 3.6.f above shall initial this block to indicate that theuser agrees with the limited or special calibration performed by the PMEL. Note: On versions of this label without anINI block, initial in the label border adjacent to the Date Due block.5.4.7 Certification Labels for SPRAMS items. AFTO Forms 99/108/394/398 (as applicable) shall be used on individualTRUs for SPRAMS. The certificates shall be completed per the general instructions except as follows:5.4.7.1 IDENTIFICATION NO Block. Also enter “SPRAMS”.5.4.7.2 SPECIAL Block. Once the item is removed from SPRAMS, the user shall enter the date the item wasremoved.5.4.7.3 DATE CALIBRATED Block. Enter the original calibration date.5.4.7.4 DATE DUE Block. Leave this block blank. Once the item is removed from SPRAMS, the user shall enter thenew due date or NHA then notify the scheduler of the new date due. The calibration due date shall be computed using theassigned calibration interval starting from the date the TMDE is removed from SPRAMS.5.5 AFTO FORM 256, NO CALIBRATION REQUIRED LABEL.The AFTO Form 256 (see Figure 5-8) shall be affixed to those items of TMDE listed as NCR in a CMS or TO 33K-1-100-2.NOCALIBRATIONREQUIREDAFTO FORM 256 OCT, 62U.S. GOVT PRTG OFF 1975 659-427Figure 5-8. AFTO FORM 256, No Calibration Required Label.5.5.1 Affixing and Validation Responsibility. Organizations that possess NCR TMDE are responsible for affixing andvalidating the AFTO Form 256 for these items.5.5.2 Validation. This label shall be validated with a PMEL K stamp, or the inspection/ production stamp or initials ofthe user of the TMDE5.5.3 PMEL NCR TMDE. On NCR TMDE designated PMEL or AFPSL responsibility in the CMS or TO 33K-1-100-2,annotate the OWC and bar code label number (if assigned) on the AFTO Form 256.5.5.4 Small NCR TMDE. On NCR TMDE too small to affix the label, a white dot can be used in place of the AFTOForm 256.5.6 NIST REPORT OF MEASUREMENT.This report is completed by NIST on all Air Force measurement standards calibrated by NIST. A copy of the report shallremain with the standard.5.7 CALIBRATION CERTIFICATES OR CALIBRATION REPORTS.5.7.1 AFPSL Calibration Certificate or Report. The AFPSL completes this certificate or report when a formalcertificate/report is required or requested for base measurement standards, Air Force measurement standards and TMDE.When issued, the certificate or report shall contain the required information in paragraph 5.7.3.5.7.2 PMEL Calibration Certificate or Report. The PMEL completes this certificate or report when requested by a useror as directed by the calibration TO or other directive. When issued, the certificate or report shall contain the requiredinformation in paragraph 5.7.3.5-8