animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC

6 ParameterThe selection options of the single parameters are described in each case. The defaults are printed in italics. In the following illustrationsof the different menue index cards the maximum number of parameters is shown. Besides this and depending on the parameter settings,objects which are not required are blended out.6.1 Menue index card "General"Selection of motor typeOptions:• DC without Encoder• DC with EncoderOver the parameters it is defined which motors are to be connected to the motor outputs. DC motors without encoder have a two-wire connectingcable (white, gray). DC motors with encoder have a three-wire connecting cable (white, grey, purple).DC motors without encoder: Somfy LV 25-B44 and B64, Somfy LW 25-B44 and B83, Somfy LT 28-B73, J101DC motors with encoder: Somfy LW 25-E83m The selection of the motor type applies to all four motor outputs.Motor output linkOptions: • 1+1+1+1• 2+1+1• 2+2Over this parameter, the motor outputs can be connected device-internally with each other. A connection is necessary when for example,two motors are used to control a screen. This means that two motors are integrated into one Din rail and move one motor.Independent of the type of connection, 2+1+1 or 2+2, all motor cables must be connected to the motor outputs. To control the motoroutputs, only the object and parameter of one motor must be parametered. For example when connecting 2+1+1 only the objects andparameters for motor 1.animeo KNX 4 DC/E Moco • Ref. 5055608B - 20/54