animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC
animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC
animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7.4 First diagnosis7.4.1 Warning LED (m) on the <strong>Motor</strong> <strong>Controller</strong>When an UP or DOWN command is given and the warning LED flashes red (m excess current), the following points must be checked:• Short circuit on the motor output or at least a wire is not connected.• Encoder wire (purple) is connected incorrectly on the motor output (e.g. M1 connector 1 or 2).• A <strong>DCE</strong> motor is connected, the <strong>Motor</strong> <strong>Controller</strong> is however in the DC mode.• A DC motor is connected, the <strong>Motor</strong> <strong>Controller</strong> is however in the <strong>DCE</strong> mode.In the mode selection <strong>DCE</strong>:When an UP or DOWN command is given and the warning LED flashes yellow (m regulator error), the set speed concerning the size ofthe Venetian blinds is too high. The set time for the UP and DOWN direction must be appropriate (increased).7.4.2 Visual display with error identifying<strong>Motor</strong> 1 ..........................................<strong>Motor</strong> 2 ..........................................<strong>Motor</strong> 3 ..........................................<strong>Motor</strong> 4 ..........................................To switch off the error display briefly press the Reset/Prog button (0.5 seconds).animeo <strong>KNX</strong> 4 DC/E Moco • Ref. 5055608B - 51/54
Change language