animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC

Cyclic montoring time in sec. (0-255)Options: • 0• 0 - 255The cyclic monitoring time is active, as soon as a higher value than “0“ is entered and refers to both security objects, low and high priority.m With active cyclic monitoring time, attention must be paid to the fact that the time of the cyclic transmitter is lower approx. 1/4 than theparametered cyclic monitoring time for both security objects, low and high priority.If the predefined value "0" remains set, the security objects react statically to the values "1" and "0".6.11 Menue index card "Special functions motor 1-4"Below the parameters for motor 1 are described. The parameters for motor 2-4 are corresponding.m This card is only visible with "Selection motor type DC with encoder" on the card "General".Motor 1Automatic slat shakeOptions:• No• YesWith selection of "Yes" the slats tilt automatically when reaching the lower end limit. Here, the slats are once completely opened and closed.m This function allows to possibly set up the slats automatically. It may happen that during a DOWN order some slats get entangled in thetilting cords and therefore do not stop in the mechanical default position. With a complete opening and closing of the slats the entangledones go back into the mechanical default position.animeo KNX 4 DC/E Moco • Ref. 5055608B - 42/54