animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC

7 Diagnosis7.1 LEDs on the animeo KNX Motor ControllerThe LEDs on the animeo KNX Motor Controller can be used for the following functions:• Functionality of the device during operation (230 V / KNX bus voltage conncted, indication via radio signals, ...)• A limited overview of the settings7.2 Informationen during operationReceiving of radio message ......................................................Safety low/high or object "block function" is active ...........................The device is ready for operation, display reception KNX telegram ........7.3 Status of the configurationm The call-up of the status of configuration is possible only in the delivery state, before the device was programmed with the ETS. As soonas the device is programmed with the ETS, the status of the configuration can no longer be called up over the Reset/Prog button. When thedevice is unloaded by the ETS, the status of the configuration can be called up again over the Reset/Prog button. A call-up of the status isalways possible over radio functionality (green upper LED).LED On (2 s) Blinking•))) = Green Radio operation acknowledged No radio operationSCR= YellowVertical awning with saved running and tiltingtimesVertical awning without saved running and tiltingtimesEU= OrangeVenetian blinds EU ergonomics withsaved running and tilting timesVenetian blinds EU ergonomics withoutsaved running and tilting timesUS= RedVenetian blinds US ergonomics withsaved running and tilting timesVenetian blinds US ergonomics withoutsaved running and tilting timesm For an explanation of EU / US ergonomics see chapter 1 Definitions.animeo KNX 4 DC/E Moco • Ref. 5055608B - 50/54