animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC

Repeat last telegram after securityOptions:• No• YesIf this parameter is set to "Yes", the last move command is repeated after security. This means that it will move to the position which wasactive before a telegram with the value "1" was input to one of the corresponding security objects, low or high.6.6 Menue index card "Binary input 1 ... 4, A/B"General information for push button binary inputFour different basis functions can be selected for each push button input:• Venetian blind, UP / DOWN• Switch/Dry contact• 8-Bit value (rising edge)• DimmingThe single functions and parameters will be explained which arise depending on the selection of the basis functions. For this another basisfunction has been selected for each push button. The functions are described with the help of the input 1 contact A/B and are identical forthe inputs 2-4, contacts C/D, E/F and G/H. For the basis function "Venetian blind UP / DOWN" attention must be paid to which contact "UP" or "DOWN" is switched. The same applieswith selection of the basis function "Dimming", for "Brighter" or "Darker" dimming. The pre-setting of the basis function for the menu indexcard push button 1 ... 4 is Venetian blind UP / DOWN.Basic functionOptions:• Venetian blind, UP / DOWN• Switch/Dry contact• 8-Bit value (rising edge)• Dimminganimeo KNX 4 DC/E Moco • Ref. 5055608B - 30/54