animeo® KNX 4 DCE Motor Controller WM/DRM 220-240 V AC

3.1 Motor outputsMax. current per output: 500 mA.Compatibel with the following Somfy motors in combination with the CTS 25 enrolling system for Venetian blinds:LV 25-B44, -B64DC-Mode2 wiresLW 25-B44, -B83DC Mode2 wiresLW 25-E83DCE- Mode3 wiresLT 28-B73DC Mode2 wiresStehleJ 1012 wiresm Control of non Somfy motors only on request3.2 CablingmAs soon as the 230 V and the KNX bus voltage supply are attached, the "US" LED blinksregularly. The device is operational when the "US" LED is blinking continuously.CABLEConnections to Cables Twisted pairs Max. distanceMotorsSwitchesGroup controlMin.: 3 x 0.6 mm/22 AWGMax.: 3 x 2.5 mm 2 /14 AWGMin.: 3 x 0.6 mm/22 AWGMax.: 3 x 2.5 mm 2 /14 AWGMin.: 3 x 0.6 mm/22 AWGMax.: 3 x 1.5 mm 2 /16 AWG— 20 mRecommendedRecommendedKNX Bus 2 x 0.8 mm/20 AWG Required, following KNX topologyguidelines220 - 240 V AC Min.: 3 x 1.5 mm 2 /16 AWGMax.: 3 x 2.5 mm 2 /14 AWG—100 m50 m3.3 Checking the move directions of the end productsGroup control of the motors 1 - 4 over the group control inputThe move directions of the motors can be checked via the group inputs. All four motor outputs are switched simultaneously. This input canbe blocked in the ETS parameters. In the event of bus power failure, it is always freed to allow emergency operation.m When starting up, make absolutely sure that the motors move in the right direction. This check can be carried out by making a wiringbridge at the group input.Check the correct move direction of the end productDOWN: The end product moves down (bridge between C + )STOP: The end product stops (bridge between C + + )UP: The end product moves upwards (C + )animeo KNX 4 DC/E Moco • Ref. 5055608B - 7/54