Control Systems - Uniclima

1 Individual control system3. Wired remote controller1) MWR-WS00(4) Additional functionsPower failure of wired remote controller1 Temperature control with built-in temperature sensorWhat if communication block occurs on the wired remote controller when its built-in temperature use is enabled ?(Block due to either power failure or disconnection only)• When communication is blocked over 3 minutes, Indoor unit ignores the built-in temperature sensor and accepts its sensor in the indoor unit. Ignores heating mode temperature compensation setting by the remote controller and acceptsK5 switch setting on the indoor unit PCB.• When communication resumes, Built-in temperature use is recovered. Setting temperature compensation in heating mode changes to 0°C(0°F).2 Recovery of parameter settingFunction Power failure recovery Parameter storageCurrent time YES (for 2 days) Wired R/CSchedule setting YES Wired R/CBuilt-in temperature sensor Compensation NO (re-setting required) Wired R/CIndoor unit RMC address YES Indoor unitOption code setting YES Indoor unitButton lock setting NO (re-setting required) NONEUpper/Lower set temperature limit YES Wired R/CAutomatic Stop YES Wired R/CFan direction setting NO (re-setting required) NONEIndoor unit RPM compensation NO (re-setting required) NONEStop EEV step under Heating mode NO (re-setting required) NONEFilter replacement time NO (re-setting required) NONEIndoor unit heating compensation[+2°C(3.6°F), +5°C(9°F]NO (re-setting required)NONE16