Control Systems - Uniclima

1 Individual control system3. Wired remote controller1) MWR-WS00(4) Additional functionsService mode menu descriptionMenu Detailed description DisplaySW 8 OFF : Monitor the compensation value of thetemperature sensor in thewired remote controllerSW 8 ON : Set the compensation value for temperaturesensor in the wired remote controller.Compensate temperature sensor for wired remote controller:To compensate and display the measured temperature on thetemperature sensor in the wired remote controller.(ex : Actually measured temperature 20°C(68°F),and compensate 5°C(9°F) It is displayed as 25°C(77°F)when indoor temperature is displayed).SW 8 OFF : Monitor whether indoor unit’s FAN RPMcompensation is usedSW 8 ON : Set indoor unit FAN RPM compensationCompensation of FAN RPM of the indoor unit:A function to increase the FAN RPM in the indoor unit(ex : When compensation is set, RPM is changed from low tomedium.)0 : Use the default RPM of the indoor unit(Use the indoor unit PCB switch setting as it is.)1 : Set indoor unit RPM 1 level Up compensation.2 : Cancel indoor unit RPM compensation.Temperature compensationvalue -9~9°C (-16.2~16.2°F)RPM compensationstateSW 8 OFF : Monitor the EEV step for the stopped indoor unitunder the Heating mode.SW 8 ON : Set the EEV step for the stopped indoor unitunder the Heating mode.0 : Use the default setting for indoor units(Use the default setting for indoor unit PCB switch).1 : Fixed step to 0 or 80.2 : Fixed step to 80. Setting value of the EEV stepfor the stopped indoor unitduring heatingSW 8 OFF : Monitor the filter replacement timeSW 8 ON : Set the filter replacement timeFilter replacement time:Set the indoor unit filter replacement time.0000 : Use the default setting for indoor units.(Use the default setting for indoor unit PCB switch.)1000 : Replacement display after 1000 hours.2000 : Replacement display after 2000 hours. Filter replacement notice timesetting18