user manual - Utax

Default Setting (System Menu)LAN Interface: a b*********************1 *Auto2 10Base-Half3 10Base-Full6 Press the OK key. LAN Interface appears.TCP/IP (IPv4) Setup7 Press the or key to select the desired LANinterface.The available LAN interfaces are as follows:Auto10Base-Half10Base-Full100Base-Half100Base-Full8 Press the OK key. Completed. is displayed and thescreen returns to the Network Setting menu.8Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway addresses.The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off".NOTE: Prior to the IP address entries, obtain permission from the network administrator.Use the procedure below to setup the TCP/IP (IPv4) setting.Sys. Menu/Count.:a b1 Report2 Counter*********************3 System[ Exit ]1 In the Sys. Menu/Count. menu, press the or key toselect [System], and press the OK key.Login User Name: L b*******************Login Password:A login screen will appear. Then, enter the user ID andpassword with administrator privileges to log in, andpress [Login] (the Right Select key).[ Login ]System:a b*********************1 Network Setting2 I/F Block Set.3 Security Level[ Exit ]2 The System menu appears.8-121