MiCOM P921/P922/P923 - Schneider - error

Technical GuideP92x/EN FT/H42User GuideMiCOM P921/P922/P923 Page 19/70TIME23:03:10Description: setting of the current timeRange: 0-23 for hours, 0-59 for minutes and seconds.NOTE:during the settings, if one of the data exceeds the minimum ormaximum value, then the following message will appear:INCORRECTDATA2.2 “ORDERS” Menu (P922 and P923 only)This menu gives the possibility:and the modifications are not taken into account.−to send open or close orders to the Circuit Breakers from the front panel.Open and close orders are written in the event file. This action generates a“Control Trip” alarm, which can be inhibited. If inhibited, the “trip” LED and the“Alarm” LED are not lit if the relay RL1 is ordered by a control trip information(affected to an input in the “configuration/inputs” submenu).−to start a disturbance recording from the protection relay.To gain access to the ORDERS menu from the default display, press followed by until the desired submenu header is displayed.ORDERSHeading of the ORDERS menuOpen OrderClose OrderDisturb rec startNoNoNoDescription: Sends manually an open order from the localcontrol panel. This order is permanently assigned to the Tripoutput relay (selected with “automatic control/Aux output rly”menu).Range: No, Yes. (the “confirmation ?” cell will be displayedafter setting change)Description: Sends manually a close order from the localcontrol panel: RL2 to RL8 (if configured)Range: No, Yes (the “confirmation ?” cell will be displayed aftersetting change)Description: Trigs a disturbance recording from the relaysHMI.Setting range: No, Yes (the “confirmation ?” cell will bedisplayed after setting change).Range: Yes/No