MiCOM P921/P922/P923 - Schneider - error

P92x/EN FT/H42Page 36/70Technical GuideUser GuideMiCOM P921/P922/P923To gain access to the “COMMUNICATION” menu from the default display, press once and 3 times. The HMI is described below:COMMUNICATIONHeading of the “COMMUNICATIONS” menuCOMMUNICATION ?YESBAUD RATE19200 BdPARITYSTOP BITSRELAY ADDRESSNONE11Description: selection of the function "COMMUNICATION"Range: YES/NODescription: selection of the baud rateRange: 300/600/1200/2400/4800/9600/19200/38400 BaudsNote: message only seen if the communication has beenenabledDescription: selection of the parityRange: NONE / EVEN / ODDNote: message only seen if the communication has beenenabledDescription: selection of the stop bits numberRange: 1 or 2Note: message only seen if the communication has beenenabledDescription: selection of the Modbus address of the relayRange: 1 to 255.Note: message only seen if the communication has beenenabled2.5.3.3 IEC60870-5-103 interfaceThe IEC60870-5-103 interface is also a master/slave interface with the relay as theslave device. This protocol is based on the VDEW communication protocol. The relayconforms to compatibility level 2, compatibility level 3 is not supported.To gain access to the “COMMUNICATION” menu from the default display, press once and 3 times. The HMI is described below:COMMUNICATIONHeading of the “COMMUNICATIONS” menuCOMMUNICATION ?YESBAUD RATE19200 BdRELAY ADDRESS1Description: enable/disable the "COMMUNICATION" functionRange: YES/NODescription: selection of the baud rateRange: 9600 or19200 BaudsNote: message only seen if the communication has beenenabledDescription: selection of the IEC address of the relayRange: 1 to 255.Note: message only seen if the communication has beenenabled