N5161A/62A/81A/82A/83A MXG Signal Generators User's Guide

Basic Digital Operation (Option 651/652/654)Multiple Baseband Generator SynchronizationFigure 8-27 Multiple Baseband Generator Synchronization (BBG Synchronization) Trigger Softkeys and Menu LocationNote: The BBG sync feature automatically configures the trigger settings shown below. To avoid a settings conflict error in thisprocess, manually configure the trigger settings prior to setting the BBG sync parameters shown on page 220.see page 142see page 172Greys out for slave instruments.Remains active for the masterinstrument.see page 220BBG sync automatically changes the trigger type to Trigger and Runif the current setting is Free Run or Gated. If desired, manually setdifferently on either the master or slaves, or both either before orafter configuring the BBG sync setup parameters.Free Run and Gated are unavailable choices while using BBG sync.Master default settings. Ifdesired, change thesesettings after designating theinstrument as the masterSlave default settings. Thesesettings are not accessibleafter selecting an instrumentas a slave.Note: A setting conflict error occurswhen at the time of the master/slaveselection, the following trigger setting(s)is true:Master• Free Run or Gated trigger typeSlave• Free Run or Gated trigger type• Ext Polarity Neg trigger sourceNeg is the factory default setting.The slave selection changes it toPos. If desired, manually change toPos prior to selecting as a slave.For details on each key, use key helpas described on page 42.Agilent N5161A/62A/81A/82A/83A MXG Signal Generators User’s Guide 219