N5161A/62A/81A/82A/83A MXG Signal Generators User's Guide

Basic OperationWorking with FilesWorking with Instrument State Files• Saving an Instrument State on page 71• Saving a User Preset on page 71• Recalling an Instrument State on page 71• Recalling an Instrument State and Associated Waveform File on page 72• Recalling an Instrument State and Associated List File on page 72• Moving or Copying a Stored Instrument State on page 73Figure 3-11 Save and Recall SoftkeysWhen saved to the signal generator, instrument settings(states) save to instrument state memory*. Instrumentstate memory is divided into 10 sequences (0 through 9);each sequence comprises 100 registers (00 through 99).Delete softkeys in the Save and Recall menus enable youto delete the contents of a specific register, or the contentsof all sequences in the state file catalog.The signal generator requires that you confirm a deletion.For details on each key, use key helpas described on page 42.*CautionTo avoid the loss of data, GPIB settings, or current userinstrument states that have not been permanently savedto non-volatile memory, the MXG should always bepowered down either via the MXG's front panel powerbutton or the appropriate SCPI command. MXG's installedin rack systems and powered down with the system rackpower switch rather than the MXG's front panel switchdisplay a Error -310 due to the MXG not being powereddown correctly.The following information is not stored in a state file:System Security Level List Mode Freq Hostname Remote Language FM DeviationSystem Security Level Display List Mode Power IP Address FTP Server PM DeviationSystem Security Level State List Mode Dwell Subnet Mask Manual DHCP MACWeb Server (HTTP) List Mode Sequence Default Gateway VXI–11 SCPI User Power CorrectionSockets SCPI (TELNET) Display State On/Off ARB Files List Files I/Q Calibration Data70 Agilent N5161A/62A/81A/82A/83A MXG Signal Generators User’s Guide