Manual Samsung SCU-VAC/VAC1 Positioning System

CAMERA SETUP (SCU-2370) The camera setting section in this manual is explained based on SCU-2370.For SCU-9051, refer to page 40. For SCU-VAC products, refer to the own user manual provided separately.Focus and Zoom Settings Focus Mode- AUTO : Performs continuous auto-focus.- MANUAL : Changes the camera mode to Manual Focus.- ONE SHOT : Auto-focuses the camera once after the Pan,Tilt, or Zoom function is used. Digital ZoomEnables the maximum digital zoom.Digital zoom magnifies from x2 to x16, which provides withzooming up to x592 in maximum when applied with the opticalzoom.M Unlike the optical zoom, the graphics quality of the digital zoom decreasesas its zoom ratio increases.The auto-focus function may not operate normally under the followingconditions :- When background illumination is low- While Slow-Shutter is in operation- If the zoom level is set too high- When background illumination is too high- If a long distance object and a close distance object appear togetherwithin a monitoring area- If there is no contrast, e.g. the sky or a wall- If the camera is facing a thin horizontal lineAuto Focus focuses on an object in the center of the screen; objects around thescreen edges may not be properly in focus.Main MenuCamera SettingSequence SettingP/T Setting OSD Setting Alarm Setting Initialize StatusCamera SettingFocus & ZoomWhite BalanceExposureBack LightAGCSSNRSSDRDay & NightOthersATWOFFMEDIUMMEDIUMFocus & ZoomFocus Mode ONE SHOTZoom TrackingDigital Zoom OFF● SETUP (SCU-2370)English - 29