Manual Samsung SCU-VAC/VAC1 Positioning System

More documents

Recommendations

Info

setupSSNR(Samsung Super Noise Reduction)SSNR significantly reduces the amount of low luminance noise.----OFF : Disables the noise reduction function.LOW : Reduces only a small amount of noise, but generatesalmost no afterimage.MEDIUM : The most commonly used mode. Reduces a suitableamount of noise while generating a subtle afterimage.HIGH : Reduces noise signifi cantly, but generates obviousafterimages.Main MenuCamera SettingSequence SettingP/T Setting OSD Setting Alarm Setting Initialize StatusCamera SettingFocus & ZoomWhite BalanceExposureBack LightAGCSSNRSSDRDay & NightOthersATWOFFMEDIUMMEDIUMM SSNR is not available if AGC is set to OFF or MANUAL.36_ setup
SSDR(Samsung Super Dynamic Range)SSDR illuminates darker spots of an image while retaining thesame light level for brighter spots to even out the overall brightnessof the image with high contrast between bright and dark spots.Main MenuCamera SettingSequence SettingP/T Setting OSD Setting Alarm Setting Initialize Status● SETUP (SCU-2370)- Mode : Enables or disables SSDR.- Range : Defi nes a range of SSDR.- Level : Changes the contrast between bright and dark spotsby the level.Camera SettingFocus & ZoomWhite BalanceExposureBack LightAGCSSNRSSDRDay & NightOthersATWOFFMEDIUMMEDIUMSSDRMode ONRange NARROWLevel 08English - 37
Page 1 and 2: Positioning SystemUser ManualSCU-23
Page 3 and 4: safety informationCAUTIONRISK OF EL
Page 5 and 6: important safety instructions1. Rea
Page 9 and 10: SCU-2370SCU-9051SCU-VACSCU-VAC1WHAT
Page 11 and 12: Back● INTRODUCTION❶➋➌➍❶
Page 13 and 14: CCTV ZOOM LENZSLA-12240 12-240mm 1:
Page 15 and 16: Camera Wiring Interface BoardFor th
Page 17 and 18: CAMMENUSEARCHMULTIRECMONESCMENUPRES
Page 19 and 20: Communication Method SettingsSelect
Page 21 and 22: CAMERA ID DIP SWITCH SETTINGSAssign
Page 23 and 24: CAMMENUSEARCHMULTIRECMONPTZ DVR MTX
Page 25 and 26: To install the light projector1. Fi
Page 27 and 28: USING AND SETTING THE MENUSOSD (On-
Page 29 and 30: CAMERA SETUP (SCU-2370) The camera
Page 31 and 32: White BalanceThe White Balance menu
Page 33 and 34: Back LightUnlike other cameras, Sam
Page 35: AGC(Auto Gain Control)AGC (Automati
Page 39 and 40: OthersSync : Enables selecting Inte
Page 41 and 42: Comm. Setting (SCU-9051)- Parity: Y
Page 43 and 44: NUC (Calibration)4.Press the SET bu
Page 45 and 46: SPECIAL (Environment Settings Mode)
Page 47 and 48: Sequence SettingPresetThis function
Page 49 and 50: MD Function’s Prerequisite when u
Page 51 and 52: Home PositionSets one of the curren
Page 53 and 54: Group SEQSelecting Group SEQ recall
Page 55 and 56: Auto RunIf there is no controller o
Page 57 and 58: P/T SettingPan/Tilt LimitThe moving
Page 59 and 60: Area Masking (SCU-2370/VAC/VAC1)If
Page 61 and 62: Wiper (SCU-2370/VAC/VAC1)You can us
Page 63 and 64: Image Hold (SCU-2370)While in Group
Page 65 and 66: ALARM SETTINGSetting Up Alarm Input
Page 67 and 68: M Connecting the power connector a
Page 69 and 70: Camera Default Set : (SCU-2370)This
Page 71 and 72: Problem Cause and Solution Page►
Page 73 and 74: product specificationsPRODUCT SPECI
Page 75 and 76: Pan / TiltPan Range360° EndlessSCU
Page 77 and 78: EXTERNAL DIMENSIONS (SCU-2370/VAC/9
Page 79 and 80: EXTERNAL DIMENSIONS (SCU-VAC1)● P
Page 81 and 82: Wall Mount72.16.5153.7● PRODUCT S
Page 83 and 84: MEMO
Page 85 and 86: MEMO

Manual Samsung SCU-VAC/VAC1 Positioning System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?