1996 Buick Park Avenue Owner's Manual

SOURCE: Press this button to change to the tape ordisc function when the radio is on. If both a tape and adisc are installed, the system will first go to tape play;TAPE will appear on the display. If SOURCE is pressedagain, the system will go to disc play; CD will appear onthe display.EJECT The system has two EJECT buttons. Press thebutton near the CD slot to remove a disc. Press the buttonnear the tape slot to remove a tape. The radio will play.CLN: This message may appear on the display. If itdoes, your cassette tape player needs to be cleaned. Itwill still play tapes, but you should clean it as soon aspossible to prevent damage to your tapes and player. See“Care of Your Cassette Tape Player” in the Index. Afteryou clean the player, press and hold EJECT for fiveseconds to reset the CLN indicator. The radio willdisplay --- to show the indicator was reset.Your cassette tape player automatically reducesbackground noise from tapes encoded with Dolby NR.You may turn Dolby off by pressing the number six preset.Dolby Noise Reduction is manufactured under a licensefrom Dolby Laboratories Licensing Corporation. Dolbyand the double-D symbol are trademarks of DolbyLaboratories Licensing Corporation,Playing a Campact DiscInsert a disc partway into the slot, label side up. rneplayer will pull it in. The disc should begin playing.If you want to insert a CD while the ignition or the radiois off, first press EJECT or RECALL.If you’re driving on a very rough road or if it’s very hot,the disc may not play and an error code may appear onthe display. Press RECALL to take the error code off thedisplay. When things get back to normal, the disc shouldplay. If the disc comes out, it could be that:0 The disc is upside down.0 It is dirty, scratched or wet.0 It is very humid. (If so, wait about an hour andtry again.)RECALL: Press this button to see which track isplaying. Press it again within five seconds to see howlong it has been playing. To change what is normallyshown on the display (track or elapsed time), press theRECALL button until you see the display you want,then hold the RECALL button until the display flashes.3-25