User Manual MV1-D1312(I) CameraLink®Series - Machine Vision

$#%"!A PinoutsFigure A.2: Power supply plug, 7-pole (rear view of plug, solder side)Pin I/O Type Name Description1 PWR VDD +12 V DC (± 10%)2 PWR GND Ground3 O RESERVED Do not connect4 PWR STROBE-VDD +5 .. +15 V DC5 O STROBE Strobe control (opto-isolated)6 I TRIGGER External trigger (opto-isolated), +5 .. +15V DC7 PWR GROUND Signal ground (for opto-isolated strobe signal)Table A.2: Power supply plug pin assignmentA.2 CameraLink ® ConnectorThe pinout for the CameraLink ® 26 pin, 0.5" Mini D-Ribbon (MDR) connector is according tothe CameraLink ® standard ([CL]) and is listed here for reference only (see Table A.3). Thedrawing of the CameraLink ® cable plug is shown in Fig. A.3.CameraLink ® cables can be purchased from Photonfocus directly(www.photonfocus.com). ! " # $ % & ' ! " # $ % & ' ! " # $Figure A.3: CameraLink cable 3M MDR-26 plug (both ends).86