AHG Solutions Guide_Edition 2.7

HEAT PUMPS
Revere CO 2
- Air to Water Heat Pumps
CHP-15F Dimensional Data and Installation Guide
Contents
Dimensions
Operation output, Error output, External input terminal board
Terminal - Remote controller, HP communication×2
Supply hot water stop valve terminal board
Power source terminal board
Air discharge outlet
Grounding terminal
(Inside the electric device BOX)
Air suction inlet
91 for rear leg
Heat pump outlet piping (B side) connection (R3/4)
Heat pump intlet piping (A side) connection (R3/4)
91 for rear leg
Grounding
Drain piping connection for venting air (R1/2)
terminal
(Make sure the connection for the possible successive drainage)
Anchor bolt position, Piping connection (Top view)
Product mass
Operating
weight
Drain hole (
35 hole)
Remote control cord & others lead-in position
Connection for heat pump outlet piping (B side)
Connection for heat pump inlet piping (A side)
Power cable lead-in position
Connection for air vent drain piping
Use four M12 anchor bolts with the
buried length of more than 60mm
Drain hole (
20 hole)
Anchor bolt notch hole
(M21 for bolt×4 spots)
Installation Guidelines
FRONT VIEW SHOWING FRONT VIEW TOP SPACE SHOWING TOP SPACE
REQUIRED FOR REQUIRED MAINTENANCE FOR MAINTENANCE
PLAN VIEW SHOWING PLAN VIEW SHOWING • This unit is not for indoor
CLEARANCE SPACES CLEARANCE REQUIRED SPACES REQUIRED installation. Outdoor
installation only.
• Consult your sales store
when obstacles are at three
directions, and for a built-in
installation.
• Do not set this unit in a closed
depression with all sides
deeper than 1.0M
ARROW DENOTES AIR ARROW INPUT DENOTES AIR INPUT
AND OUTPUT DIRECTION AND OUTPUT DIRECTION
18