SAILOR TT-3084A Fleet 77 SAILOR TT-3086A Fleet 55 - Polaris-as.dk

IMN numbers
4444
Chapter 4: Operation
Note The IMN-number has to be defined before the service can be routed
to an interface. The service will not be listed in the routing table
unless it has an IMN-number defined. (Note that the External Ringer
is not a service and does not need an IMN number).
Note Some users want the IMN number to reflect the corresponding
telephone number. In this case the user should EDIT the default IMN
number. The INSERT function is only for adding additional IMN
numbers. (or for creating the first IMN in case the list is empty).
When entering one of the above submenus it is possible to scroll through a list
of all relevant IMN-numbers for the interface. In the handset menu, you will
see all IMNs associated with voice: Mini-M voice, Speech, 3.1 kHz audio. The
ISDN menu has the same, but in addition also the services 64 kbit/s and
56 kbit/s and, if enabled, 2x64 kbit/s and 2x56 kbit/s.
Changing routing status
If an IMN has an incoming route to an interface it is marked with “*”. If it has
an outgoing route to an interface, it is marked with a “#”.
It is possible to change the routing-status for each IMN to the opposite by
pressing * for incoming and #
for outgoing. Note that the External
ringer cannot be changed; it is always an output.
Routing an IMN to more interfaces
It is possible to route one IMN to more interfaces. E.g. an IMN can be routed to
all three RJ11 interfaces at the same time. This will enable an incoming call to
be routed to three 2-wire phones simultaneously.
External Ringer
Calls to Handset #1, Handset #2, RJ11 #1, RJ11 #2 and RJ11 #3 can be routed to
an external ringer connected to the I/O interface. The output signal for the
external ringer is activated when an incoming call to the routed interface is
Super User functions 67
Operation