CICS Transaction Gateway V5 The WebSphere ... - IBM Redbooks

User (vmlinux1.itso.ibm.com:(none)): cicsrs3
331 Password required for cicsrs3.
Password:
230 User cicsrs3 logged in.
ftp> cd /tmp
250 CWD command successful.
ftp> bin
200 Type set to I.
ftp> put ctg-5.0.0-1.s390.rpm
200 PORT command successful.
150 Opening BINARY mode data connection for ctg-5.0.0-1.s390.rpm.
226 Transfer complete.
Once we had uploaded the CICS TG install RPM, we performed the following
steps.
Installing the CICS TG
We installed the CICS TG RPM using the command rpm -Uvh
ctg-5.0.0-1.s390.rpm, which made the Red Hat Package Manager program
install the CICS TG into the /opt/ctg/ directory. We then ran the CICS TG install
script ctginstall, which was created when the CICS TG was installed. The
transcript is shown in Example 9-4.
Example 9-4 Installing the CICS TG
root@vmlinux1:/ > cd /tmp
root@vmlinux1:/tmp > rpm -Uvh ctg-5.0.0-1.s390.rpm
ctg #################################################
Run the command 'ctginstall' to complete the installation.
root@vmlinux1:/tmp >ctginstall
This displayed the CICS TG install prompt asking us to enter 1 to view the
license agreement, as shown in Example 9-5.
Example 9-5 CICS TG install script license prompt
To install CICS Transaction Gateway you must accept the following license
agreement.
If the license file does not display
correctly, try restarting the
installation using the command:
'/opt/ctg/bin/ctgsetup 40'.
Enter 1 to view the license, or 2 to quit.
We viewed the agreement by entering 1. We entered 1 repeatedly until we had
viewed the entire license agreement, as shown in Example 9-6 on page 218.
Chapter 9. TCP connections to the Gateway daemon on Linux 217