Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6.2 Operational Problems<br />
Troubleshooting 6-2<br />
Jaguar II User Manual<br />
Some mechanical problems or failure during operation will cause some problems. The error<br />
messages shown on the LCM present the problem first, and followed by recommended actions.<br />
If the problem still exists after the recommended actions have been done, have your cutting<br />
plotter serviced.<br />
Error, Check Media<br />
Or Drum or X Motor<br />
Error, Check Media<br />
Or Y Motor<br />
Error, Check Carriage<br />
Sensor or VC Motor<br />
Graph Was Clipped.<br />
Data In Buffer<br />
This message indicates that there might be a<br />
problem on the X axis. Check if the drum is<br />
working well and if the media is well loaded.<br />
Correct the problem and re-power on to reboot<br />
system.<br />
This message indicates that there might be an<br />
obstruction to carriage relating to a problem on<br />
the Y axis. Correct the problem and re-power on<br />
to reboot system.<br />
This message indicates that the blade up/down<br />
sensor malfunction. Re-power on to re-boot<br />
system. If the problem still exists, find a<br />
serviceman.<br />
This message indicates that the cutting exceeds<br />
the cutting limit. Reload larger media or re-scale<br />
the plot to a smaller size; then press the key<br />
followed by the display of LCM to continue.